I'm enjoying this warp. I got confused when my weaving is opposite of the photos in the pdf, and decided I tied up upside down. But my supplementaries are down, when they are supposed to be, and up when they are supposed to be.
Any advice or any errata I might have missed? I'm weaving on a Louet Delta and I tied up the rising shed instructions, so the last 4 rows: shafts 134 rise, 234 rise, 1 rises, 2 rises.
I was a rank newbie when I started this series, and am not very technically inclined to think this through.

I triple checked and they are. I don't know how to send a photo with This app. If you refer to the last page of photos, that's what the reverse of my fabric looks like, my weaving has the floats on top. The swish and kiss portion, I stepped on the " downs" so of course that is the same.

I thought all along that I had it backwards and would switch it after the piece was done, then I realized at the end, if I did that the "downs" would be "ups" and so that's not right.

Yes, I checked again! And I notice that, still looking at the last page, the photo says 134/23, and 134/24 for 1/4", and 134/23 for another inch. On the tie up graph, 134 is labeled "up". And on my warp, those floats are up. (But in the picture, the supplemental floats are down. )So I must say your ploy has been eminently successful-- I'm certainly developing an understanding of how the tie up, and shafts work together to make the desired effect on the cloth!! Thanks for your replies.

Thanks, I'm happy! I will be interested to see what the girls say, as I'm still learning. And quite capable of big, obvious blunders, which I want to correct!
But I love your classes and your teaching style. I've got so much enjoyment out of this series. Thank you for the online format.

I got the sample off the loom where I can see it well. I went off the rails on the sections with 134. I will reverse just that set, and I'll be happier.

Last post today, I promise. Sandra can take that off her list! I moved the tie ups for the supplementaries on the two pedals I have labeled 431 and 432, so they sink. The fronts I left alone so not to mess up the 1-2-1-2 sequence. Now I'm getting the same as the photo!
And I learned to think through what was happening. Thanks for your prompt responses!

What I did: I put the tie ups back like the pdf says. Then I looked at the first warp and decided I want the sections that contain instructions fortreadle 134 to be flipped, so the floats are all on the same side. Then I figured out which is the opposite tie up, keeping the 1-2-1-2 sequence the same of course. Then I wrote a new treadle note for those sections. So "5 picks 134/23, 5 p 2/14, 5 p 134/23 BECAME 5 p 1/24, 5 p 234/13, 5 p 1/24.
It worked and was simpler than trying to adjust the tie up.